Where did EDP Settings go on SPC Firmware 3.9.1

[jasperhb]

Hi,

I'm trying to reconfigure my SPC Web Gateway to run on a different server. This means changing the Receiver IP Address.

Now, the thing is that I've since updated to SPC Firmware 3.9.1 and the current SPC Web Gateway manual is aligned to a much earlier version. Specifically, I'm no longer able to identify the EDP Receiver Settings in the new SPC Web interface when running in Full Engineer mode.

Any advice would be appreciated.

Thank you.

[gol]

Hi Jasper,
Have'nt installed 3.9.1 yet, but in 3.9.0 you find it here: Communications->Reports->EDP. Probably it is in same place in 3.9.1

//Goran

[jasperhb]

Exactly. Thanks. Was starring my self blind on this. Reporting just didn't compute.

[stephan@ats]

hey all,
have talked to the supplier today, and have said that EDP is taken out in one of the following firmware updates to v4. because it is very outdated and causes problems with the knx module of spc x500.
they say they are going to work on flex-c protocol.
we are going to see if it is so.

because I had a problem with edp to emizon.
the translation sometimes did not correspond to sia coding

Greets stephan,
The Netherlands

[gol]

Just to infom you.. According to Vanderbilt Product Manager their are no plans to phase out EDP.