No SIA 'BA' event raised

SPC Web Gateway support issues
Post Reply
beanian
Posts: 2
Joined: Sun 12 Feb 2017, 15:39

No SIA 'BA' event raised

Post by beanian »

Hi,
I'm using the spc-node-mqtt to integrate with my home automation controller. I'm having an issue when an alarm is activated. The only event I receive when the alarm is activated is a 'ZO' event. I was expecting to also receive a 'BA' event as the alarm is sounding.
I have logged every SIA message received to the console and no other related events are received. I also see the same behaviour on the test webpage when I connect the WebSocket. I have check the EDP settings on the Panel and 'Alarm Activation' is one of the selected event to send to the SPC Web Gateway.
Any Ideas?
Regards,
Ian
gol
Webbplatsadministratör
Posts: 72
Joined: Sun 01 Jun 2014, 19:38

Re: No SIA 'BA' event raised

Post by gol »

Are you sure that the BA event is not just delayed. The delay time is set in System Timers -> Dialler Delay (default is 30 seconds I think)
If you have defined multiple areas, it is also important that you check the correct area in EDP filter settings.

//Goran
beanian
Posts: 2
Joined: Sun 12 Feb 2017, 15:39

Re: No SIA 'BA' event raised

Post by beanian »

Aha! That's it. I wasn't aware of that timer.
Thanks for your help :D
Post Reply